Recent content by BC

  1. BC

    P00B7 Overheat Issue Chevy Sonic 1.8

    Thermostat was changed approximately one year ago. Should I be looking for a correlation signal between the radiator coolant temp sensor and the engine coolant temperature (ETC). Or is there a common issue with the thermostats? I do believe the water pump is working. About all I have is a...
  2. BC

    A/C Electrical ? 2005 Dodge Neon2.0

    Look what I found. Plug connector (High Pressure Switch) looked like it was fully engaged, but it is all broken up with plastic pieces. When I first checked this, I probed it with meter through the wire shield (trying to save some time) I didn't think about pulling the plug out until today...
  3. BC

    A/C Electrical ? 2005 Dodge Neon2.0

    Yes code is still active so I'll recheck it. Thank you Kev2. This sure is a big help.
  4. BC

    A/C Electrical ? 2005 Dodge Neon2.0

    After looking at the pdf Kev2 sent, I'm back to thinking the pcm is the issue. Both RAD fan relays are working. Temp switch is new so ect signal should be working. I jumped the low pressure and high pressure switches so the a/c switch sense should be reading closed loop. Only thing left is...
  5. BC

    A/C Electrical ? 2005 Dodge Neon2.0

    Pulled code P0480, I replaced the coolant sensor and now I'll see what happens. Update... Got power to both rad fan relays. Fan 1 will not come on, but relay is closed so the circuit should be energized. with the engine running, I pull rad fan relay #1 out and fan 2 will automatically come on...
  6. BC

    A/C Electrical ? 2005 Dodge Neon2.0

    No I haven't scanned for a code but I did see the check eng light was on, I'll do that next. I did think the fans should have come on a lot earlier but they never did. Yes, I meant relay switch under the hood in the box is the one I was referring to where I jumped. Also, I filled the system up...
  7. BC

    A/C Electrical ? 2005 Dodge Neon2.0

    Wow, this some good info! Thanks everyone!!! I jumped the solenoid and compressor kicked on and low pressure side was about 15psi, high side was around 150 so I'm going to add some Freon and check for leaks. When I first hooked the gauges up with ac off I had a reading of 115 on low side so I...
  8. BC

    A/C Electrical ? 2005 Dodge Neon2.0

    I haven't had much experience with ac so if this seems like a dumb question... Would the high-pressure switch be on the low side, downstream of the expansion/orifice? Or should I look around the condenser area and before expansion valve? Things sure are tightly packed in this car. lol. Thx
  9. BC

    A/C Electrical ? 2005 Dodge Neon2.0

    I'm trying to fix this car for a college kid and seemed to be stumped. A/C was working great then stopped at store got back in the car and it stopped working according to the owner. I checked all the fuses and solenoids including ones under the hood and all are good. I check the low pressure...
  10. BC

    Brake Master Booster Parts?

    Thanks, I'll give them a call today. Found an 03 Tundra today at a junk yard so I'm heading that way to see if it's doable. thank you for the info!
  11. BC

    Brake Master Booster Parts?

    Yelp, 10-4 on the glasses.:cool: I did the same, searched everywhere online. Only thing I found after several emails was that Honeywell Bosch took over some of Bendix older seals. No definition on what's older, but maybe 03 fits. Googled until my brain was fried looking for distributors and...
  12. BC

    Brake Master Booster Parts?

    Well, I dug it out and low and behold I see Bendix stamped on it with these numbers. ATP-63 and 2518607 Looks very close to the one shown in your pic above Nick. Now, another attempt to locate.
  13. BC

    Brake Master Booster Parts?

    Wow Nick, I didn't think an o-ring would get you all fired up like that lol! Thank you spending your valued time searching google! I probably have 4 hours or more of exhaustive searches myself, and is why I ended up here. Never-the-less, your time is appreciated! It's not a total loss even...
  14. BC

    Brake Master Booster Parts?

    Hey Nick, Dan is right I'm talking about the seal that fits inside the booster (red arrow) The push rod, off the master cylinder (blue arrow), is where I believe the seal is made for the vacuum between the two. It may be a day or so, but I'll take the master off and see if I can remove the...
  15. BC

    Brake Master Booster Parts?

    MAKE: Toyota MODEL:Tundra YEAR:2003 MILES:300K ENGINE:4.7 DESCRIBE ISSUE.... Anyone know where I can find a seal for the brake power booster? 03' Tundra 4.7 ext cab 2wd. 300K miles Where the push rod goes into the power booster there's a seal and it is cracked causing emissions code. Found it...