Latest activity

  • T
    TerryJ replied to the thread Sonic coolant consumption.
    I didn’t realize it vaporized that quick, but that makes sense. I don’t have a way of pressurizing it here, so it looks like I’ll have...
  • B
    billr replied to the thread Sonic coolant consumption.
    Looking for coolant leaks when the engine is hot is of limited use; the hot coolant "flashes" to vapor as soon as it leaks out and...
  • dabunk
    Jack up front end and spin wheels independantly. When tightening axle nut no pressure on bearing itself only the solid inner races. No...
  • T
    TerryJ replied to the thread Sonic coolant consumption.
    I just got back and left car running and looked all around the water outlet and water pump area for any signs of leaks with an...
  • T
    TerryJ replied to the thread Sonic coolant consumption.
    It looks like the wing tore off causing the car to go out of control. I was at an NHRA race one time when the rear wing tore off a top...
  • T
    TerryJ replied to the thread Sonic coolant consumption.
    It looks like the wing tore off
  • nickb2
    nickb2 replied to the thread P1000 on 2001 Ford F-150 5.4L.
    Ford Motor Company Driving Cycle Description of OBDII Drive Cycle The following procedure is designed to execute and complete...
  • nickb2
    nickb2 replied to the thread P1000 on 2001 Ford F-150 5.4L.
    Now I know I am going to sound like an arsehole, but you need to heed step 14. Most times, ppl cannot get a monitor drive cycle to clear...
  • nickb2
    nickb2 replied to the thread Sonic coolant consumption.
    As per billr's advice, call your local autozone if you have one close by to you, they should have a kit that looks like this to loan...
  • B
    I doubt you could ever over-tighten the nut enough to affect the bearings; the threads in the nut or on axle would strip long before...
  • K
    kev2 replied to the thread P1000 on 2001 Ford F-150 5.4L.
    Is everything working - fuel gauge- temp correct- speedo? Your only issue is a PID for a o2 sensor? no pending codes, other monitors...
  • T
    TerryJ replied to the thread Fuel stabilizer.
    Okay, according to the code on the side of the bottle, it says 14253-81337-13:27. So I'm seeing that it was made on September 10, 2014...
  • T
    TerryJ replied to the thread Fuel stabilizer.
    Thanks kev2, I'll check it now
  • Mobile Dan
    There are two classic mistakes made when "pressing in" that type of spindle/bearing/hub repair. 1. When pressing the bearing into the...
  • K
    kev2 replied to the thread Fuel stabilizer.
    https://www.coolridesonline.net/news-blog/how-do-i-know-if-my-sta-bilis-still-good-to-use/