Recent content by autojoe

  1. A

    P0303 p0420

    Can drive continously without any problem just don't shut down. Starts up no problem then problem only under load condition.
  2. A

    P0303 p0420

    All plugs and coils were replaced by garage. Won't misfire until shut off when engine hot no problem restart just will misfire under load but only after it has been shut off and restarted. Can drive for ever if you don't shut off. If you let sit for hours it is okay.
  3. A

    P0303 p0420

    Starts runs fine until you shut it off then with engine hot starts fine but under load misfiring mil flashing. If you don't shut off engine hot will not act up until you shut off restart and under load will misfire. If let set a couple hours will not act up. Any ideas? Thanks Joe
  4. A

    Leaking brake pressure modulator valve assembly

    Sticker probably not readable. Think it is awd or 4wd.thanks
  5. A

    Leaking brake pressure modulator valve assembly

    2006 chevy Tahoe 5.3 flex fuel brake pressure modulator valve assembly leaking rusted out. Like 5 different part numbers on alldata. With and without luxury edition. With jl4 without jl4 which is active brake control. The truck has traction control. Is there a way to look at rpo codes and which...
  6. A

    key programming pin code

    I don't do enough chrysler to warrant buying the tool.
  7. A

    key programming pin code

    Watch two videos that new level auto has on you tube. Keith does mobile diagnostics in long Island New York.
  8. A

    key programming pin code

    For what the dealer wants you can buy this tool to retrieve pin and program new keys
  9. A

    Short to voltage testing

    Have alldata thanks for the info.
  10. A

    key programming pin code

    Obdstar x100 Google obdstar. Watch also on YouTube. New level auto has couple good ones.
  11. A

    key programming pin code

    I assume you don't have two working keys. There is a tool that can retrieve the pin code and also program the key.
  12. A

    Short to voltage testing

    Have a p0108 5 volts on map signal wire. Map sensor connector disconnected have 5 volts on ref circuit 5 volts on signal wire and 0 volts on ground wire. I know some potentiometers the pcm uses a 5 volt bias voltage on the signal wire. What's the best way to tell if the 5 volt ref circuit is...
  13. A

    No start 2001 chevy 8.1 fixed

    Thanks for everyone's help. Only had 1.2 volts on pin 19 ignition feed from ecmb fuse and had 12 volts at fuse. Problem was half way from power distribution box underhood and pcm pin 19. Corroded wire. Started right up. Thanks again.
  14. A

    No start 2001 chevy 8.1 fixed

    Thank you