Search results

We are currently an independent shop that lost its Chrysler franchise back in 09. We are now interested in getting the WiTech up and running again. Not sure what the software level is right now. Do I need to erase the software from 09? Could it be updated from that level? Do You have to...

We have in the shop a 98 Chrysler Concorde 3.2l vehicle was towed in for a no start late in the day, next morning it fired right off the first 6 times until it wouldn't start after sitting a few hours. No faults with good fuel psi and quality. Cam and crank sensors not present on scanner, I...

purge duty cycle was at 0% on freeze frame...

thanks, no other fault codes or issues. I ran the LDP monitor test numerous times passing them all.

I also removed the charcoal canisters, shook the heck out of them and didn't see any charcoal fall out

we have in the shop and 02 dodge ram 5.9L. p0442 evap medium leak fault set, leak checked evap system with Chrysler eeld no leaks present with smoke. Leak checked with the 5psi air, flow ball dropped to bottom indicating no flow/leaks. Replaced leak detection pump, 100 miles later the same...

The aftermarket world is offering a clear or a black bezel in the headlight assembly for a 01 dodge neon. The black is a Little more affordable than the stock clear, is there any change in visibility with the black one? Thanks Will

Wow, thanks to everyone for the professional response. I swapped injector 5 and 7, no change into the misfire. removed the valve cover and found the intake rocker bolt broken with the push rod missing. With the gamble of not being able to find the pushrod the customer just had us fix the...

1999 Dodge Ram V-10, vehicle came to our shop missing badly. Check plugs and wires, plugs excessively worn with five of them carbon traced. Replaced plugs and wires engine is misfiring on cylinder 7 only when a load is applied. Compression is 160psi, injector ohm is 13.9, ignition coil tests...

ok thanks Danica I will do that, and also check the pcv system.

??? We have in the shop an 08 avenger with a 2.4L R engine, vehicle went into limp home mode on the customer with the only fault code p2173-High airflow/vacuum leak detected (slow accumulation). Sprayed entire intake manifold with carb and choke cleaner, no leaks; check brake booster as per...

thanks for your response I will check that. I know have the pcm pin-out box connected to the vehicle and tie-straped out of the way, my hope is to get the vehicle to act up and a code active so i can pull it in and do the voltage drop tests to try and determine what is causing this. So far...

Thanks for taking the time to read my post. We had a 2008 Chrysler pacifica come in the shop with the throttle body light illuminating at times. Fault codes active after a short drive are p2135 tps 1/2 correlation, p0221 tps 2 circuit performance, and stored p0223. All three codes were...

Thank you everyone for your response. it seems the vibration is felt through the floor area, it really shakes your legs. The tires were checked over by the tire shop were they were purchased, they claimed the tires still looked great and weren't out of balance. We have been notifying the...

Well we got the car in the shop, all steering components are tight. There is very slight play in the right front wheel bearing but we went ahead and replaced the right front CV shaft. Unfortunately the vibration is still present, though the customer thinks it isn't as severe it still has a...

Thank you everyone for your response. We have them scheduled to come back in next week to look into it more, I will post our results then.

Didn't notice any change turning left or right. Wonder if an assistant can duplicate the problem on the hoist and hope to see something that way.

We are working on a 2001 Oldsmobile Aurora 3.5L V-6, 207,000 miles, tranny was rebuilt 30,000 miles ago, new Michellin tires 12,000 miles age, no modifications, all maintenance and work has been done at our shop for the last 8 years (except tranny r&r and rebuild). While accelerating to highway...

we have a 2000 chevy s-10 in the shop. Last winter was a complaint of hvac blowing only from the vents, I replaced the fransfer case switch and drained out about 4 qt OVER the fill plug of the tansfer case and added a few quarts to the transmission. After so the hvac work more like it should...

thanks everyone for the response, there are no added on electronics, charging system is ok with the battery being original it did fully charge. Customer stated it flickered from dim to bright (oncoming traffic would flash their lights to dim his).