Search results

  1. G

    Fuel pressure testing

    Have you looked at the fuel rail?
  2. G

    Battery power (voltage) level drops below level to crank engine

    The only time these battery tests are accurate is when the test fails.
  3. G

    Battery power (voltage) level drops below level to crank engine

    That test is not adequate. A load test will usually draw about 250 amps and see if it holds at 10.5 or above.
  4. G

    Codes not adding up

    If it idles OK unplugged the sensor is bad. The MAF is a straight data. No learning.
  5. G

    Codes not adding up

    Does it do that with the sensor unplugged?
  6. G

    Codes not adding up

    That fail at key on tells us it's in the wiring or bad sensor. When the PCM sees a failed MAF circuit it will figure load based on TPS, VSS, RPM etc. It will usually run OK like that.
  7. G

    Battery power (voltage) level drops below level to crank engine

    Load test the battery.
  8. G

    Code B1086:08

    Are you having problems with the HVAC unit?
  9. G

    Pulley removal on mower

    If I remember I think I used a power steering pump pulley puller or a steering wheel puller. One or the other will get it.
  10. G

    Leaks antifreeze

    Fix the no start and then go after the leak. Does it crank?
  11. G

    2006 Ford Escape 2.3L XLT

    Where are you losing B+?
  12. G

    Installed CV axle seal (into transmission) approximately 1mm too deep. A problem?

    That seal don't have a shoulder? Should be fine either way.
  13. G

    Can't get rid of harsh 1-2 shift in 4l60e

    Sounds like they rebuilt the VB valve body.
  14. G

    Can't get rid of harsh 1-2 shift in 4l60e

    I was thinking these were OBDII.
  15. G

    Can't get rid of harsh 1-2 shift in 4l60e

    Did you guys flash the TCM and PCM?
  16. G

    2000 Ford Explorer 5.0L Eddie Bauer running rough

    Start a thread.
  17. G

    Vehicle is lugging

    Only in 6th gear. Sounds like the converter locking and unlocking.
  18. G

    Vehicle is lugging

    Nothing to go on. Could be anything could be nothing.
  19. G

    2018 Acura Oil Leak Dilemma

    Yes, and they should have dropped it all and sealed it. That is the only real FIX.
  20. G

    2018 Acura Oil Leak Dilemma

    Is there a spacer between the pan and the block?
Top