Search results

I understand it takes a tester that has two gauges. One for low pressure and one for high pressure. What I need is the port locations and pressure reading charts.

I am needing a procedure for line pressure testing not broken axle. thanks

Is it possible to get a procedure posted? either Alldata or ProDamand Thanks

:beer:

will do, thanks

Sometimes a corroded fuse can cause all kinds of issues like that. I've seen cars that had all kinds of lights on dash and codes for electrical systems and found nothing wrong. When I checked each fuse by removal and cleaning each one the problem was fixed even though none of the fuses were...

thank you how do I check those items? I am guessing the input splines require trans removal? I will remove the pan this weekend to look at filter.

Just a curious question ,,, do Dodge avengers have problems with transmissions? This car was driving and then parked for a few hours and now it has no forward and no reverse, I just hear a whine when placed in any gear. I checked the fluid level, even though no dipstick. and it seems ok and...

Awesome thank you so much. This truck simply not working for both outside mirrors up and down, in and out work as expected.

Nick that looks like the inside mirror on the windshield, if I'm reading correctly. I need the schematic for the left and right outside mirrors and switch on driver door that has the up-down-left (in)-right (out) and select left or right mirror. The vehicle has in and out working but not up and...

Thank you, yes sir busy as anything so much going on it's just crazy.

When everything went to computers all those books that had good accurate information on parts and demission, are now in landfills

I'm trying to find a power mirror diagram for power mirrors, also fuse locations. Mirrors are inop. Codes display as B1600-02 and B1600-04 with B1544-04 driver mirror and passenger mirror.

FYI, found zero psi compression on #5 next step is a leak down test. Early in this thread I mentioned #5 was the plug hole full of coolant.

Check ( remove and clean) all the cables and fuses, sometimes a fix is as simple as removal and replacement of a fuse. OBD II fault code B1676 is a manufacturer-specific trouble code. “Battery Pack Voltage out Of Range”, and is set when the PCM (Powertrain Control Module) detects an abnormal...

If you connect a test light to the power wire at the compressor and watch it turn on and off to verify the power circuit is working, then leave the light in place. If the compressor turns off but the light remains on then it is not the circuit but a defective compressor. We had a car that...

Yes two wire, It had new plugs, new coils, new injectors when the intake was replaced by (not me) I can tell you vss should be 0 because I can't even drive it 20 feet be fore it dies and that is with a lot of throttling. I will recap asap I intend to pull plugs to verify original coolant in...

I might have mentioned this but when I am running the engine and at engine shut down I hear a hollow sound, sorry it is hard to describe.

I adjusted the clamp that is not seated in position, the hose on the right shows heat wear but seems ok but I'll replace it.

Ok will do. Than you Just to be clear this engine starts when cold and only runs for a short time before running terrible and dies. Also when I try to restart after dying, it takes part open to wot to get it to start and it just runs horribly bad and if I place the transmission in any gear it...