Search results

  1. A

    Front p/s pulley shaft seal leaking

    Sorry gr and bill. My phone camera sucks in imaging. However, in the kit you Showed. I believe won't work. I had pulled many pulleys. But want to be safe than sorry. Again, I'm able to place a 10 mm external hex head torx or Allen socket. 90° L type Allen key because of its internal hexagonal...
  2. A

    Front p/s pulley shaft seal leaking

    2006 Hyundai Tuscon gls 2.7l 164k miles My serpentine belt shredded. Managed to wrap around power steering pump pulley and torn front p/s pulley shaft seal. The pulley itself has no lip to grab where puller could affix to pull off it's shaft. The front view of pulley shaft has a...
  3. A

    P0300 on my 2005 GMC 2500HD with a 6.0L and 350k KM.

    I would and will get some . Just fighting it. Hops this helps kiddo. I'll look over sometime early tomorrow.
  4. A

    P0300 on my 2005 GMC 2500HD with a 6.0L and 350k KM.

    Hey...the barometric psi. I'm at +2500 ft. I used to live in Chicagoland area were it's sealevel and last place of residence in whiting, In. The key on engine no start here in Arizona in Tuscon I wasn't aware of the bpsi and threw me off course a little season considering I looked over and gave...
  5. A

    Rodents ate my wires for lunch!!

    Need the color or wire color code to the female side. the one i cannot figure out is 3, 4, 7, 8, 10, 15. The male side changes its color. Its a 16 pin connector and its C-140. looked around on internet and cannot find as this is a 2.7L turbo/supercharged - one of them-lol. illustrations don't...
  6. A

    Rodents ate my wires for lunch!!

    thanks Bill
  7. A

    2002 suburban Sputters/bucks at highway speed then shuts off

    Being that many miles, you've done a lot of driving. Anyhow, 3 things ring a bell. 1) dist. Cap and rotor. When they get warm they cause many issues. Especially when humid out. 2) possibly stretched timing chain. Probably off just a little bit. That one I believe you could only adjust cam in...
  8. A

    Rodents ate my wires for lunch!!

    Okay, ....I just need a wire schematic of the engine wire harness. The connector C-140 is at interest. Most likely field rats or possums etc...chewed it up and left me with no clue on several wires as the rubber conduit that color code been chewed clean off. I'm sort of stuck here. Could someone...
  9. A

    Rodents ate my wires for lunch!!

    .... 2016 Lincoln Mkx 2.7L 46,000 miles Hi im in need of a pinout on connector #140 (c-140) near or at top of passenger front wheel in engine compartment. Whatever rodent chewed on it only ate the female side of it. Id attempted to solder and heat shrink but left me half-guessing...
  10. A

    Fixed! 2014 Mercedes-Benz CLA 250 2.0L 4cyl turbo Engine R and R

    Oh yeah, to mention. It needed an alternator as debris shot off into the inner side of alternator and was hidden.
  11. A

    Fixed! 2014 Mercedes-Benz CLA 250 2.0L 4cyl turbo Engine R and R

    OKAY!!! this one is fixed. Sorry to take so long on replying. It was better to take this engine and trans as an assembly from top. By the pics shown the sides of this engine at timing cover has a long hole along the side of alternator and opposite side. The timing chain and components shot off...
  12. A

    Fixed! 2014 Mercedes-Benz CLA 250 2.0L 4cyl turbo Engine R and R

    Well there was about 4 to 5 inches I'm guess but in the opposite traffic direction the both maybe going 30. However I believed through the opposite side and the RIP in current trucks were passing me up might of shot something underneath the vehicle. I'm sort of guessing on a probable scenario...
  13. A

    Fixed! 2014 Mercedes-Benz CLA 250 2.0L 4cyl turbo Engine R and R

    Thanks because I was considering that first. Until that thought flew in my head that I better ask! So basically in s sense there is no short way of doing this. "The long way is the better way!" I have much info on Mercedes Benz. But not the cls class for some reason. I may need some specs for...
  14. A

    FIXED! P0455 - 2017 Honda Pilot, 60k miles

    Just to throw this is in. I've had people that had their vehicle running while fueling up. This can throw that evap code also. Cannot have vehicle running while gassing up. Some people have a bad habit of it especially if too hot or too cold outside. Anyhow, hope this helps.
  15. A

    Fixed! 2014 Mercedes-Benz CLA 250 2.0L 4cyl turbo Engine R and R

    Okay no one replied..my question is ...what is the recomindation to remove the engine?
  16. A

    scanner

    Haven't been here for a while. I read the post and thanks for the input. However, is there a windows based software that would reprogram/flash the ecu, ecm, pcm (ENGINE COMPUTER) and the srs module? Its just taking me a little longer than it should to really determine if a ecu is the fault..at...
  17. A

    Fixed! 2014 Mercedes-Benz CLA 250 2.0L 4cyl turbo Engine R and R

    Hi my name is Alex. I have a 2014 Mercedes-Benz CLA 250 2.0L 4cyl turbo and am replacing the engine. Reason: street was a little flooded with water but able to drive still and something smacked the heck underneath and tore the oil pan along with everything else in the oil pan. Timing component...
  18. A

    scanner

    need an ob2 scanner that does bi-directional testing. Activating solenoids, etc....to be put in use all the time. Any recomendations?
  19. A

    Runs terrible at times

    Have you checked the fuel psi regulator? Could be it. Sounds like it's flooding out after awhile. Usually leaks through vacuum hose side. Just check it out before going any further.
Top