02 Liberty trouble codes and cooling issue

rjh1

Full Member
Joined
Jan 9, 2007
Messages
141
Likes
1
Points
18
Location
Ohio
#1
2002 jeep liberty sport 3.7L 115,000 miles had bank 1 sensor 1 code and map sensor code...relpaced driver side front o2 and map sensor....cleared codes after install .. also had code p1281 eng to cold to long .. put new dealer stat in .. is there a special bleeding sequence to go thru not really blowing hot .. lower hose is still cool to touch .. now have codes p0131 p0132 p0135 .. need some help here please.............Thanks ???
 
Joined
Nov 17, 2006
Messages
4,467
Likes
5
Points
38
Location
Portland,Oregon
#2
The codes you have now are for a shorted O2 sensor...here is the procedure for filling the cooling system....Jim......STANDARD PROCEDURE - REFILLING COOLING SYSTEM


Tighten the radiator draincock and the cylinder block drain plug(s) (if removed). CAUTION: Failure to purge air from the cooling system can result in an overheating condition and severe engine damage.
Fill system using a 50/50 mixture of ethylene glycol antifreeze and low mineral content water. Fill pressure bottle to service line and install cap. NOTE: The engine cooling system will push any remaining air into the coolant bottle within about an hour of normal driving. As a result, a drop in coolant level in the pressure bottle may occur. If the engine cooling system overheats and pushes coolant into the overflow side of the coolant bottle, this coolant will be sucked back into the cooling system ONLY IF THE PRESSURE CAP IS LEFT ON THE BOTTLE. Removing the pressure cap breaks the vacuum path between the two bottle sections and the coolant will not return to cooling system.
With heater control unit in the HEAT position, operate engine with pressure bottle cap in place.
Add coolant to pressure bottle as necessary. Only add coolant to the pressure bottle when the engine is cold. Coolant level in a warm engine will be higher due to thermal expansion. NOTE: The coolant bottle has two chambers. Coolant will normally only be in the outboard (larger) of the two. The inboard chamber is only to recover coolant in the event of an overheat or after a recent service fill. The inboard chamber should normally be empty. If there is coolant in the overflow side of the coolant bottle (after several warm/cold cycles of the engine) and coolant level is above cold full when cold, disconnect the end of the overflow hose at the fill neck and lower it into a clean container. Allow coolant to drain into the container until emptied. Reconnect overflow hose to fill neck.
 

rjh1

Full Member
Joined
Jan 9, 2007
Messages
141
Likes
1
Points
18
Location
Ohio
#3
Jim
I errored The codes are P0031 P0132 and P0135 what are the steps or what to look for to correct issue Thanks