Ford 5.4 fuel injector connector

nickb2

nickb2

Wrench. Diagnostic Tech.
Joined
Nov 22, 2008
Messages
12,895
Points
83
Location
St-Hyacinthe, Quebec, Canada
nickb2

nickb2

Wrench. Diagnostic Tech.
Joined
Nov 22, 2008
Messages
12,895
Points
83
Location
St-Hyacinthe, Quebec, Canada
So if you are getting my point yet, these are universal, since obd1 and a half to full on obd 2 style injectors came into market here.

hint wink etc. Hope you like this site.
 
J

jigfeett

Hero Member
Joined
May 30, 2008
Messages
422
Points
18
Location
Pacific Northwest
Thank you, that makes sense because this is an early build June of 1996.
I will investigate and let you know what I end up doing.
I must at least change the broken one but none of them are secure when trying the pull method test.
The cheap plastic wing design is garbage.
 
J

jigfeett

Hero Member
Joined
May 30, 2008
Messages
422
Points
18
Location
Pacific Northwest
Went to the junk yard and got several connectors and a few for the coils, good thing because I discovered I actually had 2 defective injector connectors and 2 coil connectors that had bad latches.
All connectors are good now and I will be test running and checking for leaks later today if possible. the connector below is a much better design but I got the factory gray ones I currently have and I hope they stay latched.
1669667011052.png
 
G

grcauto

wrench
Joined
May 29, 2014
Messages
1,346
Points
48
jigfeett said:
Went to the junk yard and got several connectors and a few for the coils, good thing because I discovered I actually had 2 defective injector connectors and 2 coil connectors that had bad latches.
All connectors are good now and I will be test running and checking for leaks later today if possible. the connector below is a much better design but I got the factory gray ones I currently have and I hope they stay latched.
View attachment 11678
Click to expand...
Make sure they have the foam seal inside.
 
You must log in or register to reply here.
Top