Inter 40S series,

nickb2

Wrench. Diagnostic Tech.
Joined
Nov 22, 2008
Messages
11,034
Points
63
Location
St-Hyacinthe, Quebec, Canada
Please fill out the following to ask a question.

MAKE:International
MODEL:40s
YEAR:1995
MILES:???
ENGINE:durastar DT466
DESCRIBE ISSUE....

Need to safety one of these hydro line trucks. I have to safety two of these line trucks but one has no flashers, no hazards, no brake lights. Running lights ok, but 8 burnt, but at least I know series circuit is good.

I am assuming they are all on the same relay or module but I have no wiring schematics for heavy trucks and google sucks as all I fond are for RV or flat bed. Does anyone have a stock wiring of this or have experience with this flasher/hazard/brake light system?

Can any one help me out?
 

nickb2

Wrench. Diagnostic Tech.
Joined
Nov 22, 2008
Messages
11,034
Points
63
Location
St-Hyacinthe, Quebec, Canada
Of note, when I put on flasher for each side, solid high volt for each side, when I put hazards on, solid high volt for both sides. So flash relay not working, but current is going to bulbs, hence circuit path is good if not nothing would light up at all. Where is the flasher relay located?
 

nickb2

Wrench. Diagnostic Tech.
Joined
Nov 22, 2008
Messages
11,034
Points
63
Location
St-Hyacinthe, Quebec, Canada
There is a whole bunch of crap located around all that section and nothing is identified. So I want to go from scratch and just redo it like from Oem. That way I know when I stamp my tech # and safety this rig it won't come bite me in the arse.
 

dabunk

wrench
Joined
Nov 14, 2006
Messages
1,564
Points
38
Age
120
Location
Belize, Central America
Website
www.facebook.com
I had a full set of manuals on these but dumped them a few years back. I will check with some friends and see what I can come up with. IH has everything online now but lost my password and logon when I got laied off
 

dabunk

wrench
Joined
Nov 14, 2006
Messages
1,564
Points
38
Age
120
Location
Belize, Central America
Website
www.facebook.com
Top